The Color Inspector: a small black 3D-printed reader with a color screen and two buttons, sitting on its swatch tray

Color Inspector

A pocket filament color reader: a spectral sensor and a small color screen in a 3D-printed case. Scan a swatch, a strand of filament or a printed part, and see how it compares with the spools you own.

What it does
  • Same batch or not?

    Scan two spools of the same color and see whether they match, finer than your eye can see.

  • Find spools by color

    Scan a swatch, a strand of filament or a printed part and see the closest spools you own.

  • Spools to use instead

    Each spool's page lists your other spools close enough to swap in when one runs out.

  • Works on its own

    No account needed: the reader keeps your last 300 scans on its own web page. Connect it to your account to save scans to your spools.

Comparing two scans is very accurate; a scan's absolute color is approximate — see what it's good at.

Buy one assembled

$99

Assembled and ready to scan. Each reader is built to order, not kept in stock: the parts are bought and it's assembled once your order comes in, so expect about 1–2 weeks before it ships.

Order at 3dcreator.shop ↗
Build your own

Free

The print files and firmware cost nothing — you buy the parts, print the case and solder it together, then install the firmware from your browser.

Color Inspector help: scan modes, calibration and what it's good at →